Archive for the 'Hobbies' Category

How To Get Started with a Gold Detector

Thursday, January 28th, 2010
Alan Jones asked:

When we really want to do something new it is easy to get pumped up and excited, the reality then kicks in on the challenges of getting started with our newly found subject. To get started with Gold Detecting the first move is to research what tools and equipment are needed, this is where it starts to get very confusing. There are so many different types of Gold Metal Detectors on the market from various manufacturers and suppliers at a wide range of prices, we can easily put off doing anything at all.

So where do we start, well sometimes it’s a question of ‘just doing it’. A good way to get up and running is to buy a very basic Gold Detector and learn by practicing your new found venture. The quality of the Metal Detectors supplied by our leading manufacturers is generally excellent, the difference between one product and another is mainly in the specification and of course the price. Compare two leading brands with similar specifications and the price and quality will usually be similar. Also look out for discounts on many models especially the lower priced ones which are attractive to people getting started.

Basically the same technology is used for most gold detectors. There many different types and models but they are all based on the same electromagnetic technology. When a magnetic field inside the gold detector is created it reacts with the magnetic field within metal on the ground. The metal detector can analyze this reaction and convert it into a signal that shows that metal has been located nearby.

Tuning is a very important factor of gold detectors  The gold detector has to be calibrated correctly to properly receive the signals from the ground, this can vary depending on what you are prospecting for. This process may need to be monitored every few minutes depending on the type of gold detector.

How you use your gold detector has a great bearing on your success rate. With some gold detectors a slow rotating action is required and others may prefer a faster action. For best results you should read the guidelines in the manufacture’s manual and follow their recommendations. Detection depth is not easy to specify by the manufactures due to various factors including ground type and moisture. It is usually not that important as you are just as likely to find your treasure close to the surface, it can also save a lot of digging!

The other key difference in the specification is the frequency. Low signal frequencies between 5-10kHz and 15-20kHz are used for most gold detectors. The reason for that is that if you are looking for objects like coins and items of jewelry then low frequencies between 5-20KHz can be used as low frequencies tend to go deeper into the ground. The multi frequency gold detectors tend to be more expensive and are therefore used by the more established gold prospectors.

So back to our original discussion, look around for a basic low cost Gold Metal Detector from one of the leading brands and just get out there and enjoy learning about Gold

Detecting, you never know what treasures you might find.

gold detector

Share and Enjoy:
  • Digg
  • del.icio.us
  • Facebook
  • NewsVine
  • Reddit
  • StumbleUpon
  • YahooMyWeb
  • Google Bookmarks
  • Yahoo! Buzz
  • TwitThis
  • Live
  • LinkedIn
  • Pownce
  • MySpace

Finding Treasures with a Gold Detector

Thursday, October 1st, 2009
Alan Jones asked:

Call it a growing hobby, a pastime or an obsession, gold detecting gets into your blood after a while. Using a gold detector can be very relaxing and sometimes mesmerizing, finding gold nuggets might be the goal but fun of prospecting for gold provides so much pleasure as an outdoor activity.

With lots of equipment, tools and books available in the market it can be quite a challenge to get started, there is also and abundance of opinions from experts trying to promote a particular brand or product which can be equally confusing. For the person looking to buy their first metal detector a popular solution is to buy a basic gold metal detector and then learn by using it as you practice gold prospecting, it is also great practice to just go out to the park, beach or wood and look for anything that gives you a signal, even that is a great thrill.

Every gold detector has pros and cons depending on how much you pay for it and what you intend to use it for. With a specialized prospecting detector you get the high efficiency of locating even small nuggets at a shallow depth. The down side is that it may have poor discriminating abilities and you might end up with digging up lots of trash. With all gold detectors patience is the key for finding gold. Do not leave the spot until you have scanned it effectively, then you can move on and mark out another area. Despite your hard work, you might not find anything, start all over again on a new location applying the same degree of concentration. With a little reading of some books on the subject, some effort and the right equipment, you too could be finding hidden treasures.

A metal detector is really not a complicated device but the specifications look quite technical. It has three basic parts, the first one is the coil which can come in different shapes, it has a power supply and a control box. Most of the job involves the control box because it is that one part that is triggered when there is metal around and this signal is what causes the gold detector to do its job.

Of all the different kinds of metal detectors, probably one of the most important is the gold metal detector. It is pretty obvious that gold is an element that is worth a lot in many ways and this makes gold metal detectors a prized possession as well. Metal detectors identify various metals by testing the conductivity of the metal. A target signal is eliminated for unwanted ferrous metals like leftover iron, steel, pull tabs and bottle tops while increasing target signals to high conductive metals as gold along with brass and silver.

Gold Panning

Share and Enjoy:
  • Digg
  • del.icio.us
  • Facebook
  • NewsVine
  • Reddit
  • StumbleUpon
  • YahooMyWeb
  • Google Bookmarks
  • Yahoo! Buzz
  • TwitThis
  • Live
  • LinkedIn
  • Pownce
  • MySpace

How to Coin Shoot in a Park With a Metal Detector

Friday, May 29th, 2009
Joseph Buffalo asked:

How To Coin Shoot in a Park With a Metal Detector.

This article will present a basic system for hunting for coins in a public park.

One of the first things you should do is to check with your city, county parks and recreation department to see if you are allowed to use a metal detector in their parks. If so they may require a permit. Most permits are free. They usually are good for a year.

Items you want to take to the park are;

* Metal detector with at least a 6″ coil

*Flathead Screw driver or other digging instrument.

*String or rope to line out your search area.

*Sand Scoop for sand play box, volleyball court or any other play area with sand.

*Water for drinking. Maybe some snacks.

If you have lived in the area for a long time you have an advantage in locating some good older parks in your city.

Sit down and think about how certain location were 20, 30, 40 years ago. Maybe you went to a local school some 25 years ago. That would be a good place to start.

Later on I am going to tell you how we found gold in a city park, worth over $300.

I like coin shooting parks early in the morning. Not so many lookie lookers. Some of the best places to coin shoot at schools and parks are around and under swings, slides, jungle gyms and similar play ground equipment. Basketball courts, Volleyball courts are very good. This is were the sand scoop comes in handy. Don’t forget any concession stands at the parks.

Before you map out your search, sit down and look over the search area. Visualize you doing what a person would be doing at the site. Lets use a volleyball court with sand base. The first area you want to search is around the fringe of the court in the grass. People will sit along the edge to watch the amateurs play. When you get a hit, use your flat nose screw driver to push down to the item and rock it back and forth. This will generally move the coin or item to the surface.

The next area of the court is in the sand. You can lay out some cord to do a grid search so you don’t overlook any section of the court. When you get a hit, use your sand scoop. We have found coins, jewelry, rings in many sand courts.

Kids seam to have a lot of loose change these days, far cry from my days, when fifty cents let me in the movies, two hot dogs and a coke. Check under the swing sets, you can locate some nice change there.

Coin Shooting is fun. Takes patients and control but sometimes it pays big.

Found over $300 worth of Gold in a city park. Read all about it at AzMuleTreasures

underwater metal detector

Share and Enjoy:
  • Digg
  • del.icio.us
  • Facebook
  • NewsVine
  • Reddit
  • StumbleUpon
  • YahooMyWeb
  • Google Bookmarks
  • Yahoo! Buzz
  • TwitThis
  • Live
  • LinkedIn
  • Pownce
  • MySpace